2014-2020 MT/FZ/FJ-09/XSR900/GT 900 tracer custom flash
If you do not understand all the settings, DO NOT FILL OUT THE FORM AT THE BOTTOM OF THE PAGE, instead send your ecu with a note with your contact information, a list of your modifications, the type of riding you do most and any requests for flash settings.
See pictures on the side for a good photo of the air box mod that is so debated. Pictures of the front cover and how to cut it can be found in the ecu removal directions in the garage section.
I do recommend it. Its FREE and adds a small amount of power across the rev range and has no negatives unless you consider even better intake noise a negative.
FTECU Active tune
When ordered with the flash I will activate active tune and set it all up so you just have to install and enjoy
If ordered by itself you will get the kit mailed to you. Note: You still must flash your ecu
Once installed and activated, the ActiveTune kit monitors the fuel mixture making fast and consistent changes to mitigate changing fuel requirements.
The breakthrough system replaces your inadequate stock O2 sensor with a proprietary FTECU lambda controller and the latest generation Bosch LSU 4.9 sensor.
– Exhaust with a standard 18×1.5 O2 sensor bung (optionally cylinder specific bungs)
– Smog block-offs or disabled AIS valveThis kit includes:
– 1 FTECU YAM-01 Lambda Controller
– 1 Bosch LSU4.9 wideband O2 sensor
– 1 Product Activation Card
Currently available models
– 2017+ R6
– 2015+ R1M / R1 / R1s
– 2016+ FZ-10
– 2016+ MT-10
– 2014+ FZ-09
– 2014+ MT-09
– 2014+ FJ-09
– 2016+ XSR900
– 2015+ FZ-07
– 2015+ MT-07
Sprint Filter P08 FZ-09 / MT-09 (14-20) FJ-09 (15-20) XSR900 (16-20)
- Innovative polyester material allows for consistent airflow
- Optimized filter surface area provides more airflow, more power and more filtration
- Increased air permeability and filtration efficiency when compared to cotton air filters
- Race proven performance in organizations like MotoGP and Moto3
- Can be cleaned using only compressed air
- Dry filter, no oil treatments required
- Direct OEM replacement
- 1 year warranty
About Sprint Filter: Established in 1952, Sprint Filter started building high performance air filters and intake systems. Ever since their inception products have always been highly innovative and based on ongoing research and development of new filtering fabrics and intake systems.
Innovative Material: The Sprint Filter P08 has completely reinvented the concept of an aftermarket air filter. The innovative polyester material that is used allows the air to remain constant and calibrated unlike cotton or sponge materials that become inconsistent under pressure. A Sprint Filter is totally different from all others and its membrane filtering surface is double that of any other filter.
Race Proven Performance: Sprint Filter has been a part of World Championships in MotoGP, Moto3, Superbike, Supersport, and Superstock. The P08 filter is the first choice of championship contenders. Research and development is constantly carried out at the highest levels of racing in search of maximum filtration without compromising power.
Low Maintenance: The Sprint Filter P08 is essentially maintenance free. Remove the filter and blow it clean with compressed air and you’re ready to go. No messy oiling or washing required.
Long Lasting: If cared for properly, the Sprint Filter P08 will last for the entire time you own your bike.
Increased Fuel Economy: By optimizing the air/fuel mixture the Sprint Filter P08 allows you to consume less fuel all the while gaining more power!
Research and Development: We spend a tremendous amount of time and effort researching the best materials to use for the production of our air filters. The air filters are made with extreme precision to make sure you get the best air/fuel ratio for making power.
Efficient Filtration: The innovative polyester Sprint Filter P08 air filter stands apart from all other special cotton air filters for its increased air permeability along with its more efficient filtration and easy maintenance. The increase in air permeability and better performance in comparison with common cotton air filters is mainly due to two essential elements: the filtering material structure is made of polyester and the filter's folds are higher. These folds are what allow for the highest filtering surface on panel filters (20 mm) and work to the fullest advantage of air permeability and the quality of dirt filtration. Moreover, the total absence of oil to contain dirt allows for increased air entry with equal surface area. Furthermore, when considering that the filtering surface is very wide, an increase in airflow of approximately 25% is obtained in comparison with a cotton filter, working to the fullest advantage of the engines performance and the guaranteed protection of increased filtration.
Besides its increased air permeability, Sprint Filters P08 ensures extremely efficient filtration; as much as 80 microns, allowing to sieve out 93.13% of 100 micron particles versus the 76.42% of 100 micron particles trapped by cotton filters. This is made possible thanks to the special structure made of 5 micron diameter yarns which are woven together to leave room for a wide surface in which air passes freely.
- Yamaha FZ-09
- Yamaha MT-09
- Yamaha FJ-09
- Yamaha XSR900
OEM Part Number: 1RC-14451-00-00
Speedometer correction rings all ABS model FZ/MT 09, XSR900, FJ09, FZ/MT 07
The rings front & rear are straight bolt on no modifications needed, are powder coated in Matt black, they will calibrate when the wheels first turn & the ABS light goes out & that is it
The Speedo will be corrected by -5%, 09 Speedo over read between +6 to +8% depending on tire thread amount new or used.
Includes both front and rear ring, no negative affects to ABS system, when installing make sure there is an air gap between the ring and sensor
Tail Tidy by Lextek
These tail tidy's from Lextek, like most of their products, provide great quality at an amazing price point
come with light for the license plate and removable brackets to mount aftermarket turn signals, adjustable for angle and height
FZ/MT 09 FJ09 XSR900 AIS block off plates
These plates are machined from solid thick billet aluminum, for positive sealing and have the Vcyclenut beasty logo machined directly into them. Then they are coated for a lifetime of worry free use.
Everything is included in the kit to remove the ais system and seal the air box
Install these plates if you want to get the least amount of popping on decal or are measuring your exhaust to obtain air fuel ratios
If you are not sure what the AIS system does please see the questions section of the website
install instructions are here
Yamaha FZ09/MT09/FJ09/XSR900/ Tracer Gt diagnostic scanner and harness
The OBD2 Diagnostic Scanner - Basic allows you to read and clear fault codes when used in conjunction with the included OBD2 Harness suitable for this series of bikes.
The newer diagnostic system Yamaha is using does not clear codes on its own if the condition no longer exists. This means you either have to take the bike to the dealer to clear the code or purchase a scanner.
works on 2017 and up FJ09/FZ09/MT09 and all models of the XSR900 and tracer GT
o2 sensor plug (wide band)
Now that you have that aftermarket exhaust and have had me disable the o2 sensor you can clean up the look by removing the o2 sensor from the bike and putting this plug in the exhaust. This only fits the larger 18 mm thread diameter wide band o2 sensor bungs found on aftermarket exhausts. Will not fit the narrow band hole found on the stock exhaust.
Annitori Quick Shifter Pro 2
This stand alone quick shifter is available for almost all makes and models!!
Because its stand alone it will work with any bike that is flashed or not flashed!!
Works independent and with any ecu flash.
Use links below to discover why you should be running with Annitori and for instructions!!
Transferable from bike to bike with new harness
Adjust kill times and sensitivity with your smart phone
SHIFT ROD INCLUDED IN PRICE!!
This is a quick shifter (up only)