2006-2019 R6 Custom Flash
The flash includes:
fueling changes to match your modifications
Ignition timing changes for best power
remove all restrictions (where applicable)
adjust velocity stack lift point (where applicable)
adjust fan temps
adjust fly by wire tables
fix speedometer error
disable exup valve ( can be removed with no CEL)
disable injector decel cut
enable ECU controlled quick shifting (hardware required)
Lifetime reflashes are included in original purchase to original purchaser. Shipping fees still apply.
FTECU Active tune
When ordered with the flash I will activate active tune and set it all up so you just have to install and enjoy
If ordered by itself you will get the kit mailed to you. Note: You still must flash your ecu
Once installed and activated, the ActiveTune kit monitors the fuel mixture making fast and consistent changes to mitigate changing fuel requirements.
The breakthrough system replaces your inadequate stock O2 sensor with a proprietary FTECU lambda controller and the latest generation Bosch LSU 4.9 sensor.
– Exhaust with a standard 18×1.5 O2 sensor bung (optionally cylinder specific bungs)
– Smog block-offs or disabled AIS valveThis kit includes:
– 1 FTECU YAM-01 Lambda Controller
– 1 Bosch LSU4.9 wideband O2 sensor
– 1 Product Activation Card
Currently available models
– 2017+ R6
– 2015+ R1M / R1 / R1s
– 2016+ FZ-10
– 2016+ MT-10
– 2014+ FZ-09
– 2014+ MT-09
– 2014+ FJ-09
– 2016+ XSR900
– 2015+ FZ-07
– 2015+ MT-07
6mm swingarms spools
Hard black anodized with quality stainless hardware. Nice lip so the stand doesn't slip off work to protect the swingarm in a crash also
R6 quick shift kit from Flash Tune
You are purchasing a quick shifter kit for an R6 Combined with your flashed ECU this will allow smooth upshifts with out changing throttle position or engaging the clutch. As long as you are above 4000 rpms, just push up on the shifter and the bike will shift to the next gear. You can still use the clutch with no ill effect, you just don't have to. This includes a new Flash Tune shift sensor, the appropriate rods , and the harness that plugs into the sensor and connects to the bikes tip over sensor harness. This will include full detailed instructions with pictures.
Shift rods must be trimmed to match total length of stock shift rod, See garage for directions
The kits now come with dual directional sensors and will work in both push and pull applications
Vcyclenut r1, r6, fz1, fz8 ais block off plates
All plate orders will come in pairs... two plates. Each order will also include an airbox cap, a zip-tie to help tidy up your intake area.
Used to seal the ports on the valve cover for the AIS (Air Injection System).
Eliminate the popping noise from aftermarket exhaust and baffle kits!
Most importantly, to get an accurate air/fuel mixture reading when tuning the bike.